Failed to morph anatomy shape to its die interface

Failed to morph anatomy shape to its die interface

07/11/2023

Problem with morphing anatomy shape 

Problem: When the library tooth model is placed too far from the margin line, the "Failed to morph anatomy shape to its die interface" error message pops up. This particular error message shows up during the Anatomy design step in Dental Designer. This issue occurs most commonly for crowns and anatomical abutments, but can also show up for other indications.  

Prerequisites: This error message will show up on all 3Shape Dental System versions and is therefore not restricted to a specific version or Dental Designer design module.

Overview of possible solutions

Solution 1: 

  • Place the anatomy as close as possible to the margin line

Solution 2: 

  • Reconnect the anatomy to the margin line by disconnecting and connecting it again to the margin line in Sculpt tools on Smile Composer step

Solution 3: 

  • Modify the anatomy design and reconnect it to the margin line again

Solution 4:

  • Select another tooth smile library 

 

Was this article helpful?

Give feedback about this article